ASTM A564 PDF

Best Stainless offers high quality standards including UNS S, AMS , ASTM A, and ASTM A Grade PH stainless steel can be used. This standard is issued under the fixed designation A /A M; the number . [ mm] round bar, 10 to 12 ft [ to m] in length, ASTM A See the chemical composition and physical properties of ASTM A Grade condition HM, find alternative materials, and connect with suppliers.

Author: Kazigar Kigashicage
Country: Ecuador
Language: English (Spanish)
Genre: Politics
Published (Last): 19 November 2016
Pages: 134
PDF File Size: 19.90 Mb
ePub File Size: 1.62 Mb
ISBN: 524-8-55930-740-2
Downloads: 63654
Price: Free* [*Free Regsitration Required]
Uploader: Arashile

ASTM A A M R_百度文库

Ast, L – Longitudinal axis of specimen parallel to direction of grain ow during rolling or forging. Applications should be limited to small diameter bar. Work Item s – proposed revisions of this standard. G Either Rockwell C hardness or Brinell is permissible.

Such requirements may include but are not limited to the following: Billets or bars for reforging may be purchased to this specication. Combining values from the two systems may result in nonconformance with the specification. Axtm of this standard are expressly advised that determination of the validity of any such asmt rights, and the risk of infringement of such rights, are entirely their own responsibility.

  IEC 60287 PDF

Historical Version s – view asm versions of standard. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. This specification covers bars and shapes of age-hardening stainless steels. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging.

This standard has been approved for use by agencies of the Department of Defense. Mechanical Properties Requirements 7.

Materials and Manufacture 5.

Time refers to minimum time material is at temperature and may be extended to obtain adtm ductility properties. NOTE 3—A typical ordering description is as follows: Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Current edition approved May 1, The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.

Hold for not less than 3 h. Type XM is machinable in the as-received fully heat treated condition.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.

  HAIRSPRAY SONGBOOK PDF

Note 2 — For billets and a5564 for forging see Specification A Type UNS S is suitable for machining in the solution-annealed, cold-worked, and aged-hardened condition. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging.

Active q564 current version of standard.

17-4 PH Stainless Steel Bar

Elongation in 2 in. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. These shapes may be produced by hot rolling, extruding, or forging. Billets or bars for reforging may be purchased to this specification.

Up to 6 in. H When air cooling is specied, gases other than air may be used. Adtm or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included.